KVM Extender / splitter NS560UTPUser Manualwww.newstar.nl
8----------------- Hotkeys Control The KVM Extender interprets keystrokes for hotkeys all the time. A hotkey sequence starts with two left Ctrl key
9-------------Remote unit Hotkeys ControlTable 5: Hotkey control for Remote Unit Note: Special hotkey ϔCtrlϕ-ϔCtrlϕ-ϔEϕ-ϔEϕ: Enable the KVM extender t
10Beep sounds UTP Cable Length 1 beep 0Д100 feet (0Дˆ˃ʳ̀˸̇˸̅̆ʼ2 beeps 100Д˅˃˃ʳ˹˸˸̇ʳʻˆ˃Дˉ˃ʳ̀˸̇˸̅̆ʼ3 beeps 200Дˆ˃˃ʳ˹˸˸̇ʳʻˉ˃Дˌ˃ʳ̀˸̇˸̅̆ʼ4 beeps 300Дˇ˃˃ʳ˹
11Table 6: Hotkey control for Local unit Note: Special hotkey ϔCtrlϕ-ϔCtrlϕ-ϔEϕ-ϔEϕ: Enable the KVM extender to link with port E of a KVM switch under
12----------------- Cascade Configuration The KVM Extender can be connected to the KVM Switch in compliance with the “Cascade Configuration”. In this
13----------------- AppendixesCable Requirements The cable interconnected between Local unit and Remote unitnormally used is Category 5(CAT5) terminat
14Note: CAT5, CAT5e or CAT6 cables are applicable to the extender pair. The above diagram shows the RJ45 connector of a CAT5 cable with its metal cont
15Limited Warranty IN NO EVENT SHALL THE DIRECT VENDOR'S LIABILITY FOR DIRECT OR INDIRECT, SPECIAL, INCIDENTIAL OR CONSEQUENTIAL DAMAGES, LOSS OF
16----------------- Notes_____________________________________________________________________________________________________________________________
Table of Contents Ŷ Introduction ... 1 Ŷ Key Features...
1------------------------ IntroductionThe KVM Extender consists of a Local unit and a Remote unit thatis suitable to locate a keyboard/monitor/mouse s
2------------------------ Key Features Connects the Local unit and Remote unit via Category 5 UTP cable Remotely locates the keyboard, mouse and m
3------------------------ Specifications NS560UTP Connection CAT 5 – RJ45 Female Remote unit Connectors Console MiniDIN6, female x 2 HDB15 fema
4------------------------InstallationNS560UTP Figure 4: Connection patterns of KVM Extenders------------------------ Video Compensation Before operati
5------------------------ Operation A keyboard and mouse must be connected to the Remote unit. And then the system conducts the emulation for local co
6Local unit Model LED Status Control Description Remote: Off, Local: On Local unit controls its local PC or KVM switches. In this mode, the Remote u
7----------------- Push Button: Switch to the control status There is a button on the panel of Local unit which can be pushed (switched) in sequence t
Comments to this Manuals